Snap-On TDM-117A Metric Tap and Die Set

Any additional photos will be below. We take pride in serving you! Check out our huge selection of diverse products.

Your satisfaction is our number one goal. Thank you for shopping at pawnamerica_e25! Snap-On TDM-117A Metric Tap and Die Set. An important feature of the dies in these sets (except GAM541 and GAM540) is a small adjusting screw which changes the nominal size. 003 under or over to give a tight or loose fit to your thread. Die size 1/4" to 1/2" and 7 mm to 12 mm are a one-piece, 12-point design that can be turned with a 1" socket wrench (5/8" socket wrench for 3 to 6 mm dies) when working in places where a normal die stock cannot be used. The three largest die stocks (TD10A, TD35, and TD40) are self-centering and adjust to the diameter of the bolt. GGG-T-60 applies to taps; GGG-D-296B applies to dies. Taps and dies from 3 to 12mm, a BSP tap and die, two die stocks, three tap wrenches, a metric thread pitch gauge, and a die adjusting screwdriver (41 pcs). Some scratches and scuffs form use.

Only what you see is included. Payments: Payments must be received within 3 days. Please note, if you enter the wrong billing address your card will be declined.

Make any changes to your address before paying. Local Pickups: We offer local pickups.

Operating Hours: M-F 9:30am - 5:30PM Central Standard Time. We do not offer Buyitnows. What is the history of the item? Most of our items are used and we do not know the history.

We test them and picture their current condition. 99% of the time, if it's pictured it's included. The item "Snap-On TDM-117A Metric Tap and Die Set" is in sale since Friday, July 03, 2015. This item is in the category "Business & Industrial\Manufacturing & Metalworking\Metalworking Tooling\Cutting Tools & Consumables\Taps\Other Taps". The seller is "pawnamerica_e25" and is located in Milwaukee, Wisconsin. This item can be shipped to United States.

Brand: Snap-On
Model: TDM-117A
Country/Region of Manufacture: United States
UPC: Does Not Apply